install flash operator panel asterisk voip

Flash Operator Panel Asterisk Voip Code In The

When I pick up the SPA-303 I hear a dial tone and can dial outside lines (dont forget the 1 for long distance.

I decided on this since I already use this for backing up computers, it runs Linux, it is always powered on and is pre-configured with.

For this project I used a 3 line Cisco SPA-303 which retails for around 60 at Amazon.

In Figure 1 below you will see a screenshot of my Asterisk GUI (v1.8) status after being configured and registered with a SIP provider (note the green registrations).

It also.

For a good list of options for trunking, visit our SIP providers section.

In Figure 2 below you can see the credentials I gathered from Flowroute, with the actual authentication details blackened out.

Flash Operator Panel Asterisk Voip Code In The

SIP providers usually offer this as a service where you can order a DID from any area code in the country.

Notice that each of my DID numbers, including the 855 toll free number is configured for SIP registration.

This is required so it can be registered by the Asterisk PBX.

This can be found under the Trunks section of the Digium Asterisk GUI.

This indicates you are connected to the SIP providers servers.

In particular port 5060 should have a path through your network.

In other words, when I use my extension 6000 and make an external call it will go through the SIP trunk with the caller ID name and number.

All access has been permitted for directory, voicemenus, queues etc.

Note the extension range can be altered in the global settings for Asterisk.

The most important aspect is setting up the MAC address for your device.

For the SPA-303 you can get the MAC address by logging into the.

For example, I set up an auto attendant using voice menus and voice prompts so the caller can hear a menu such as press 1 for sales, 2 for customer service etc.

I have a Cisco SPA-303 phone but you can use any IP phone of your choosing.

Interestingly, I found configuring the phone more complex than configuring the Asterisk PBX, mainly due to the lack of help for each parameter.

I wanted the phone to use DHCP (Dynamic Host Configuration Protocol) so it received an IP address from my router.

The settings for the extension are highlighted in Figures 10, 11 and 12 below.

The important elements here are that the SIP port is 5060, the proxy is set to the IP address of the Asterisk server.

If you are successful then the light should turn green on the SPA-303 and if you refresh the System Status in Asterisk, the phone(s) should turn green in the extensions area as per Figure 1.

Install Flash Operator Panel Asterisk Voip